Attwood 7563 Two-Position Pull Switch Uživatelský manuál stáhnout pdf

Attwood marine hardware, navigational lighting, bilge pumps, and other

marine accessories are specified more than any other brand by America’s

best-known boat manufacturers as original equipment. Look to Attwood

for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS

Form Number 69308 Rev. A 03-10

Two-Position Pull Switch

7563

Installation Instructions

REQUIRED FOR INSTALLATION

• Drill with ³⁄₈" (10mm) dia. bit.

• Slotted screwdriver.

•Pliers.

APPLICATION

• Install switch in dashboards or panels up to 1" (25mm) thick.

• Switch requires 1¹⁄₄" (31mm) depth behind panel.

• Rated load is 20 amps.

MOUNTING INSTRUCTIONS

1. Bring power source wire and switched wire to panel. Attach wires

to terminal screws.

2. Remove chrome handle and nut from shaft.

3. In desired location, drill ³⁄₈" (10mm) dia. hole through panel. From

inside panel, insert shaft through hole.

4. Tighten chrome nut and handle onto end of shaft. From inside,

tighten brass nut and washer against panel.

Figure 1

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Chrome

Handle

Chrome

Nut

3/8"

(10mm) Dia.

Brass

Nut

Brass

Washer

Panel:

1" (25mm) Max

Terminal Screw

•

Two-Position Pull Switch 1

Shrnutí obsahu

Strany 1 - Two-Position Pull Switch

3®Attwood marine hardware, navigational lighting, bilge pumps, and othermarine accessories are specified more than any other brand by America’sbest-kn

Komentáře k této Příručce

Žádné komentáře

Attwood 7563 Two-Position Pull Switch Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Hardware Attwood 7563 Two-Position Pull Switch. Attwood 7563 Two-Position Pull Switch User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Hardware Attwood 7563 Two-Position Pull Switch